1Ft ILDA Y-CABLE M to Dual F Laser Connection Cable for Quickshow FB3 Light Show Software

Introducing the ProX XC-ILDA-Y , a 1 ft. ILDA 25-pin Y-Cable built for laser professionals who need to drive two projectors from a single ILDA interface. When your show calls for a mirrored laser setup across the stage and you only have one output from your laser controller or software interface, this is the cable that makes it happen. Compact, practical, and designed specifically for this purpose, the ProX XC-ILDA-Y is an essential piece of any serious laser production rig. Connector Configuration The ProX XC-ILDA-Y features one 25-pin ILDA male connector on the input side and splits to two 25-pin ILDA female connectors on the output side. This allows a single ILDA signal source to feed two laser projectors simultaneously, making it the go-to solution for symmetric satellite projector setups. 25-Pin Full-Wire ILDA Pinout The cable carries a full 25-pin wired configuration, supporting ILDA projectors with up to six color channels. This means the complete ILDA signal, including X/Y galvo control, color modulation, and shutter signals, is passed through both outputs without reduction or compromise. Compatible with QuickShow, FB3, and Industry-Standard ILDA Systems The ProX XC-ILDA-Y is built to work directly with Pangolin QuickShow and FB3 ILDA interfaces, as well as any laser controller or projector that follows the ILDA DB-25 standard. If your setup runs an ILDA-capable DAC or software controller, this cable connects right in. Compact 1 Ft. Length At just 1 ft. in length, this cable is designed to sit close to the source device and split the signal cleanly before running longer runs of ILDA cable to each projector. The short form factor keeps your rack or controller area tidy while allowing the flexibility to route full-length ILDA cables from each female output to their respective laser units. Designed by Professionals. Built for Performers. Backed by 40 Years of Excellence. ProX products are designed by a team of seasoned industry professionals who know firsthand what it means when power fails mid-show. Since 1984, ProX has built its reputation on one principle: every product must perform as hard as the professionals who depend on it. We listen to our customers, and their real-world feedback directly shapes the products we bring to market. The ProX XC-ILDA-Y is a direct result of that collaboration. When you choose ProX, you are investing in four decades of hands-on expertise and a brand that has never stopped raising the standard for live performance gear. ILDA Y-Splitter Design Splits one ILDA signal source into two simultaneous outputs, ideal for driving symmetric dual-projector laser setups from a single controller 25-Pin Full-Wire Pinout Fully wired DB-25 configuration supports ILDA projectors with up to six color channels including X/Y galvo, color modulation, and shutter signals 1 Male to 2 Female Configuration One 25-pin ILDA male input connects to two 25-pin ILDA female outputs for clean, direct signal distribution Industry-Standard ILDA DB-25 Compatibility Works with any ILDA-compliant laser controller, DAC, or software interface following the DB-25 standard Compatible with Pangolin QuickShow and FB3 Interfaces Designed for direct use with widely adopted professional laser control systems Compact 1 Ft. Cable Length Short form factor keeps signal routing clean at the source before running full-length ILDA cables to each projector Plug-and-Play Setup No tools or configuration required, connects directly between your ILDA output and two laser projectors All registered trademarks and trade names are properties of their respective owners and are used only for the clarification of the compatibility of our products with the products of the different manufacturers. Fits: Pangolin ILDA Software, or other comapitble Controller Applications